Cisco Systems A9014CFD manual TDM Local Switching, 21-27

Chapter 21 Configuring Pseudowire

TDM Local Switching

MTU: local n/a, remote n/a

Remote interface description:

Sequencing: receive disabled, send disabled

Control Word: On (configured: autosense)

Dataplane:

SSM segment/switch IDs: 28683/16387 (used), PWID: 4

VC statistics:

transit packet totals: receive 0, send 0

transit byte totals: receive 0, send 0

transit packet drops: receive 0, seq error 0, send 0

Local interface: AT0/IMA1 up, line protocol up, ATM VPC CELL 90 up

Destination address: 180.0.0.201, VC ID: 90, VC status: up

Output interface: Vl300, imposed label stack {21}

Preferred path: not configured

Default path: active

Next hop: 110.1.1.202

Create time: 5d02h, last status change time: 2d17h

Last label FSM state change time: 2d17h

Signaling protocol: LDP, peer 180.0.0.201:0 up

Targeted Hello: 170.0.0.201(LDP				Id) -> 180.0.0.201, LDP is UP
Graceful restart: not configured and not						enabled
Non stop routing: not configured and not						enabled
Status	TLV support (local/remote)				: enabled/supported
LDP route watch					: enabled
Label/status state machine					: established, LruRru
Last	local dataplane		status	rcvd: No		fault
Last	BFD dataplane		status	rcvd: Not sent
Last	BFD peer monitor		status	rcvd: No		fault
Last	local AC	circuit status		rcvd: No		fault
Last	local AC	circuit status		sent: No		fault
Last	local PW i/f circ status			rcvd: No		fault
Last	local LDP TLV		status	sent: No		fault
Last	remote LDP TLV		status	rcvd: No		fault
Last	remote LDP ADJ		status	rcvd: No		fault
MPLS VC labels: local 16, remote 21
Group ID: local 0, remote 0
MTU: local n/a, remote n/a
Remote	interface description:

Sequencing: receive disabled, send disabled

Control Word: On (configured: autosense) Dataplane:

SSM segment/switch IDs: 4110/12290 (used), PWID: 3 VC statistics:

transit packet totals: receive 0, send 0

transit byte totals: receive 0, send 0

transit packet drops: receive 0, seq error 0, send 0

packet drops: receive 0, send 0

TDM Local Switching

Time Division Multiplexing (TDM) Local Switching allows switching of layer 2 data between two CEM interfaces on the same router.

Note Effective with 15.2(2)SNH1 release, you can configure local switching on the T1 or E1 mode.

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		21-27