Cisco Systems A9014CFD manual Configuring IP SLA for Traffic Generation, 10-58, Ip sla slaid

Chapter 10 Configuring Ethernet OAM

Understanding Ethernet Loopback

•SPAN and Traffic generator cannot be used simultaneously since both uses the mirror mechanism.

•For Traffic generation over cross connect port-channel will not be supported for both internal and external modes.

•Ethernet loopback and Traffic generator cannot be used simultaneously.

•After reload, the Traffic generator over cross connect should be rescheduled (stop and start).

•After cross connect flaps, the Traffic generator over cross connect should be rescheduled (stop and start).

Configuring IP SLA for Traffic Generation

Complete these steps to configure IP SLA for traffic generation.

SUMMARY STEPS

1.configure terminal

2.ip sla sla_id

3.service-performance type ethernet dest-mac-addrdestination mac-address interface type number service instance number

4.aggregation default description duration exit frequency measurement-type direction no profile signature

5.default exit loss no throughput

6.exit

7.default exit inner-cos inner-vlan no outer-cos outer-vlan packet-size src-mac-addr

8.exit

9.direction {external internal}

10.default exit no rate-step

11.exit

DETAILED STEPS

	Command or Action	Purpose
Step 1
	configure terminal	Enters global configuration mode.
	Example:
	Router# configure terminal
Step 2
	ip sla sla_id	Specify the SLA ID to start the IP SLA session.
	Example:
	Router(config)# ip sla 100

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
10-58	OL-23826-09