Cisco Systems A9014CFD manual Configuring an ATM IMA Interface, Clock source internal, 36-5

Chapter 36 Configuring Inverse Muliplexing over ATM

Configuring ATM IMA over MPLS

5.clock source internal

6.ima-groupgroup-number

DETAILED STEPS

	Command	Purpose
Step 1	enable	Enables privileged EXEC mode.
		• Enter your password if prompted.
	Example:
	Router> enable
Step 2	configure terminal	Enters the global configuration mode.
	Example:
	Router# configure terminal
Step 3	card type {t1 e1} slot port	Configures the IMA on an E1 or T1 interface.
	Example:
	Router(config)# card type e1 0 0
Step 4	controller {t1 e1} slot/port	Selects a T1 or E1 controller and enters controller configuration
		mode.
	Example:
	Router(config)# controller E1 0/4
Step 5	clock source internal	Sets the clock source to internal.
	Example:
	Router(config-controller)# clock
	source internal
Step 6	ima-groupgroup-number	Specifies the group number for the controller.
	Example:
	Router(config-controller)# ima-group 0

Configuring an ATM IMA Interface

Complete the following steps to configure an ATM IMA interface:

SUMMARY STEPS

1.enable

2.configure terminal

3.controller {t1 e1} slot/port

4.interface ATMslot/IMAgroup-number

5.no ip address

6.atm bandwidth dynamic

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		36-5