Cisco Systems A9014CFD manual Measurement-type direction -Specifies the statistics, 10-59

Chapter 10 Configuring Ethernet OAM

Understanding Ethernet Loopback

	Command or Action	Purpose
Step 3
	service-performance type ethernet dest-mac-addr	Specifies the service performance type as ethernet and the
	destination mac-address interface type number	destination MAC address in H.H.H format.
	service instance number	Specifies an interface type and number which traffic
		generator uses to send the packets. Also, specifies the
	Example:	service instance number that is required to create a service
		instance on an interface. The range is 1 to 4096.
	Router(config-ip-sla)# service-performance type
	ethernet dest-mac-addr 0001.0001.0001 interface
	gigabitEthernet0/10 service instance 10
Step 4
	aggregation default description duration	Specify the type of service performance. The following are
	exit frequency measurement-type direction	the options:
	no profile signature	• aggregation—Represents the statistics aggregation.
	Example:	• default—Set a command to its defaults.
	Router(config-ip-sla-service-performance)# prof	• description—Description of the operation.
	ile traffic direction external	• duration—Sets the service performance duration
		configuration.
		• frequency—Represents the scheduled frequency. The
		options available are iteration and time. The range is 20
		to 65535 seconds.
		• measurement-type direction—Specifies the statistics
		to measure traffic. The options available are external or
		internal; the default option is Internal. If you use this
		option, go to Step 5.
		• profile—Specifies the service performance profile. If
		you use the packet or traffic option, go to Step 7 or Step
		9 respectively.
		• signature—Specifies the payload contents.
Step 5
	default exit loss no throughput	Specifies the measurement type based on which the service
		performance is calculated. The following are the options:
	Example:	• default—Set a command to its defaults
	Router(config-ip-sla-service-performance-measur	• loss—Specifies the measurement such as frame loss.
	ement)# throughput
		• throughput—Specifies the measurement such as
		average rate of successful frame delivery.
Step 6
	exit	Exits the measurement mode.

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		10-59