Cisco Systems A9014CFD manual Configuring PIM SSM Mapping, 41-8

Chapter 41 IPv4 Multicast

Configuring IPv4 Multicast

DETAILED STEPS

	Command	Purpose
Step 1	enable	Enables privileged EXEC mode.
		• Enter your password if prompted.
	Example:
	Router> enable
Step 2	configure terminal	Enters global configuration mode.
	Example:
	Router# configure terminal
Step 3	ip pim ssm [default range	Configures SSM service. The default keyword defines the SSM
	access-list]	range access list. The range keyword specifies the standard IP
		access list number or name that defines the SSM range.
	Example:
	Router(config-if)# ip pim ssm default
Step 4	interface type number	Specifies an interface type and number, and places the device in
		interface configuration mode.
	Example:
	Router(config)# interface
	GigabitEthernet 0/1
Step 5	ip pim sparse-mode	Enables PIM on an interface.
	Example:
	Router(config-if)# ip pim sparse-mode
Step 6	ip igmp version 3	Enables IGMPv3 on an interface.
	Example:
	Router(config-if)# ip igmp version 3

Configuring PIM SSM Mapping

To configure PIM SSM mapping, complete the following steps:

SUMMARY STEPS

1.enable

2.configure terminal

3.no ip igmp ssm-map query dns

4.ip igmp ssm-map enable

5.ip igmp ssm-map static access-list source-address

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
41-8	OL-23826-09