Cisco Systems A9014CFD manual Configuring the Lacp Transmit Rate, Lacp rate fast normal End

Chapter 9 Configuring EtherChannels

Configuring Etherchannels

Configuring the LACP Transmit Rate

To configure the rate at which Link Aggregation Control Protocol (LACP) control packets are transmitted to an LACP-supported interface, complete the following tasks:

SUMMARY STEPS

1.enable

2.configure terminal

3.interface type number

4.lacp rate {fast normal}

5.end

DETAILED STEPS

	Command	Purpose
Step 1	enable	Enables privileged EXEC mode.
		• Enter your password if prompted.
	Example:
	Router> enable
Step 2	configure terminal	Enters global configuration mode.
	Example:
	Router# configure terminal
Step 3	interface type number	Specifies an interface type and number, and enters interface
		configuration mode.
	Example:
	Router(config)# interface
	gigabitethernet 0/1
Step 4	lacp rate {fast normal}	Configures the transmission rate of LACP control packets to an
		LACP-supported interface.
	Example:	• fast—Specifies that LACP control packets are transmitted at
	Router(config-if)# lacp rate fast	the fast rate, once every second.
		• normal—Specifies that LACP control packets are transmitted
		at the normal rate, every 30 seconds after the link is bundled.
Step 5	end	Exits the interface configuration mode and enters the privileged
		EXEC mode.
	Example:
	Router(config-if)# end

Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide

OL-23826-09 9-7