Cisco Systems A9014CFD manual 21-7

Chapter 21 Configuring Pseudowire

Configuring Pseudowire

	Command	Purpose
Step 3
	class cem cem-class-name	Creates a new CEM class
	Example:
	Router(config)# class cem
	mycemclass
Step 4
	payload-size size	Specifies the payload for the CEM class.
	Example:
	Router(config-cem-class)#
	payload-size 512
Step 5
	dejitter-buffer size	Specifies the dejitter buffer for the CEM class.
	Example:
	Router(config-cem-class)#
	dejitter-buffer 10
Step 6
	idle-pattern size	Specifies the idle-pattern for the CEM class.
	Example:
	Router(config-cem-class)#
	idle-pattern 0x55
Step 7
	exit	Returns to the config prompt.
	Example:
	Router(config-cem-class)# exit
Step 8
	interface cem slot/port	Configure the CEM interface that you want to use for the new CEM class.
		Note	The use of the xconnect command can vary depending on the type
	Example:		of pseudowire you are configuring.
	Router(config)# interface cem 0/0
Step 9
	no ip address	Disables the IP address configuration for the physical layer interface.
	Example:
	Router(config-if)# no ip address
Step 10
	cem group-number	Enters the CEM configuration mode.
	Example:
	Router(config-if)# cem 0

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		21-7