Cisco Systems A9014CFD manual Remote peer, Values for SAToP pseudowires using UDP are from, 21-13

Chapter 21 Configuring Pseudowire

Configuring Pseudowire

	Command	Purpose
Step 14
	xconnect peer-router-id vcid	Binds an attachment circuit to the CEM interface to create a pseudowire.
	{pseudowire-class name}	This example creates a pseudowire by binding the CEM circuit 5 to the
		remote peer 30.30.30.2.
	Example:	Note When creating IP routes for a pseudowire configuration, we
	Router(config-if-cem)# xconnect	recommend that you build a route from the cross-connect address
	30.30.30.2 305 pw-class udpClass	(LDP router-ID or loopback address) to the next hop IP address,
		such as ip route 30.30.30.2 255.255.255.255 1.2.3.4.
Step 15
	udp port local <local-udp-port>	Specifies a local and remote UDP port for the connection. Valid port
	remote <remote-udp-port>	values for SAToP pseudowires using UDP are from 49152–57343.
	Example:
	Router(config-if-cem-xconn)# udp
	port local 49150 remote 55000
Step 16
	exit	Exits the CEM interface.
	Example:
	Router(config-if-cem-xconn)# exit
Step 17
	exit	Exits the configuration mode.
	Example:
	Router(config-if)# exit

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		21-13