Cisco Systems A9014CFD manual Configuring Event Handler, An EEM applet is triggered, 31-9

Chapter 31 Microwave ACM Signaling and EEM Integration

How to Configure Microwave ACM Signaling and EEM Integration

	Command	Purpose
Step 8	action action-idcli command	Specifies the action of executing a Cisco IOS CLI command when
	cli-string	an EEM applet is triggered.
	Example:	• action-id—Unique identifier that can be any string value.
		Actions are sorted and run in ascending alphanumeric key
	Router(config-applet)# action 460 cli	sequence using the label as the sort key. If the string contains
	command "event tag event_sd ethernet	embedded blanks, enclose it in double quotation marks.
	microwave sd interface
	GigabitEthernet0/10 threshold $nb"	• command—Specifies the message to be sent to the Cisco IOS
		CLI.
		• cli-string—CLI string to be executed. If the string contains
		embedded blanks, enclose it in double quotation marks.
Step 9	exit	Exits applet configuration mode.
	Example:
	Router(config-applet)# exit

Configuring Event Handler

To configure the microwave event handler, which runs hold-off timer, loss threshold, and fading wait-to-restore (WTR) timers that are configurable per interface, complete the following steps:

SUMMARY STEPS

1.enable

2.configure terminal

3.interface type number

4.ethernet event microwave hold-off seconds

5.ethernet event microwave loss-threshold number-of-messages

6.ethernet event microwave wtr seconds

DETAILED STEPS

	Command	Purpose
Step 1	enable	Enables privileged EXEC mode.
		• Enter your password if prompted.
	Example:
	Router> enable
Step 2	configure terminal	Enters global configuration mode.
	Example:
	Router# configure terminal

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		31-9