Cisco Systems A9014CFD Disables the Ilmi trap parameters, Sets the PVC encapsulation type to AAL0

Chapter 36 Configuring Inverse Muliplexing over ATM

Configuring Marking MPLS Experimental Bits

8.service-policy input policy-map-name

9.xconnect ip-addressport-numberencapsulation mpls

10.atm pvp VPI l2transport

11.service-policy input policy-map-name

12.xconnect ip-addressport-numberencapsulation mpls

DETAILED STEPS

	Command	Purpose
Step 1	enable	Enables privileged EXEC mode.
		• Enter your password if prompted.
	Example:
	Router> enable
Step 2	configure terminal	Enters the global configuration mode.
	Example:
	Router# configure terminal
Step 3	interface ATMslot/IMAgroup-number	Specifies the slot location and port of IMA interface group and
		configures the ATM interface.
	Example:	• slot—Specifies the slot location of the ATM IMA port adapter.
	Router(config)# interface atm0/ima0	• group-number—Specifies the group number of the IMA group.
Step 4	no ip address	Disables the IP address configuration for the physical layer
		interface.
	Example:
	Router(config-if)# no ip address
Step 5	no atm enable-ilmi-trap	Disables the ILMI trap parameters.
	Example:
	Router(config-if)# no atm
	enable-ilmi-trap
Step 6	pvc VPI/VCI l2transport	Specifies the VPI and VCI of the PVC and configures the PVC in
		layer 2 transport mode.
	Example:
	Router(config-if)# pvc 100/100
	l2transport
Step 7	encapsulation encapsulation-type	Sets the PVC encapsulation type to AAL0.
	Example:
	Router(config-if)# encapsulation aal0
Step 8	service-policy input policy-map-name	Attaches a policy map to the input interface.
	Example:
	Router(config-if)# service-policy
	input mark_qosgroup
	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09			36-19