Cisco Systems A9014CFD manual Configuring a Port MEP, Service ma-name ma-number vpn-id port, 10-14

Chapter 10 Configuring Ethernet OAM

Configuring a Port MEP

A port MEP is a down MEP that is not associated with a VLAN and that uses untagged frames to carry CFM messages. You configure port MEPs on two connected interfaces. Port MEPs are always configured at a lower domain level than native VLAN MEPs.

Complete the following steps to configure Ethernet CFM port MEPs:

	Command	Purpose
Step 1
	configure terminal	Enter global configuration mode.
Step 2
	ethernet cfm domain domain-namelevel level-id	Define a CFM domain, set the domain level, and enter
		ethernet-cfm configuration mode for the domain. The
		maintenance level number range is 0 to 7.
Step 3
	service {ma-name ma-number vpn-id}port	Define a customer service maintenance association name
		or number or VPN ID to be associated with the domain,
		define a port MEP, and enter ethernet-cfm-service
		configuration mode.
		• ma-name—a string of no more than 100 characters that
		identifies the MAID.
		• ma-number—a value from 0 to 65535.
		• vpn-idvpn—enter a VPN ID as the ma-name.
Step 4
	mep mpid identifier	Define the static remote maintenance end point identifier in
		the domain and service. The range is 1 to 8191
Step 5
	continuity-check	Enable sending and receiving of continuity check
		messages.
Step 6
	continuity-check interval value	(Optional) Set the interval at which continuity check
		messages are sent. The available values are 100 ms,
		1 second, 10 seconds, 1 minute and 10 minutes. The default
		is 10 seconds.
		Note Because faster CCM rates are more CPU-intensive,
		we do not recommend configuring a large number
		of MEPs running at 100 ms intervals.
Step 7
	continuity-check loss-threshold threshold-value	(Optional) Set the number of continuity check messages to
		be missed before declaring that an MEP is down. The range
		is 2 to 255; the default is 3.
Step 8
	continuity-check static rmep	Enable checking of the incoming continuity check message
		from a remote MEP that is configured in the MEP list.
Step 9
	exit	Return to ethernet-cfm configuration mode.
Step 10
	exit	Return to global configuration mode.
Step 11
	interface interface-id	Identify the port MEP interface and enter interface
		configuration mode.

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
10-14	OL-23826-09