NETGEAR L3 manual Config diffserv service add, Config diffserv service remove

7000 Series L3 Managed Switch Reference Manual for Software v2.0

This set of commands consists of service addition/removal.

The CLI command root is config diffserv service.

config diffserv service add

This command attaches a policy to an interface in a particular direction. The <slot.port> parameter specifies a valid slot number and port number for the system. Alternatively, the value all can be used in place of <slot.port> to attach this policy to all system interfaces. The direction value is either in or out. The <policyname> parameter is the name of an existing DiffServ policy, whose type must match the interface direction. Note that this command causes a service to create a reference to the policy.

Note: This command effectively enables DiffServ on an interface (in a particular direction). There is no separate interface administrative 'mode' command for DiffServ.

Note: This command shall fail if any attributes within the policy definition exceed the capabilities of the interface. Once a policy is successfully attached to an interface, any attempt to change the policy definition such that it would result in a violation of said interface capabilities shall cause the policy change attempt to fail.

Format	config diffserv service add <in/out> <slot.port/all>
	<policyname>
Restrictions	Only a single policy may be attached to a particular interface in a
	particular direction at any one time.

config diffserv service remove

This command detaches a policy from an interface in a particular direction. The <slot.port> parameter specifies a valid slot number and port number for the system. Alternatively, the value all can be used in place of <slot.port> to detach this policy from all system interfaces to which it is currently attached. The direction value is either in or out. The <policyname> parameter is the name of an existing DiffServ policy. Note that this command causes a service to remove its reference to the policy.

Note: This command effectively disables DiffServ on an interface (in a particular direction). There is no separate interface administrative 'mode' command for DiffServ.

9-28 CLI Commands: Differentiated Services