7000 Series L3 Managed Switch Reference Manual for Software v2.0

config radius accounting server remove

This command removes a configured accounting server. The IP address specified must match that of the previously configured accounting server. Since only a single accounting server is supported, issuing this command will cause future accounting attempts to fail.

Format

config radius accounting server remove <ipaddr>

config radius accounting server secret

This command configures the shared secret between the RADIUS client and the RADIUS accounting server. The IP address specified must match that of the previously configured accounting server. When this command is issued, the secret will be prompted. The secret must be an alphanumeric value of 20 characters or less.

Format

config radius accounting server secret <ipaddr>

config radius server add

This command configures the IP address to use to connect to a RADIUS server. Up to 3 servers can be configured per RADIUS client. If the maximum number of configured servers has been reached, this command will fail until one of the servers is removed using the ‘config radius server remove’ command. Once a server is added, it is referenced in later ‘config radius server’ commands using the configured IP address.

Format

config radius server add <ipaddr>

config radius server port

This command configures the UDP port number to use to connect to the specified RADIUS server. The IP address specified must match that of a previously configured RADIUS server. The port number must be in the range of 0 and 65535.

Default

1812

Format

config radius server port <ipaddr> <0-65535>

Switching Commands

7-65

Page 119
Image 119
NETGEAR L3 manual Config radius accounting server remove, Config radius accounting server secret, Config radius server add