7000 Series L3 Managed Switch Reference Manual for Software v2.0

 

 

Serial Port Login

Specifies the time, in minutes, of inactivity on a Serial port con-

Timeout (minutes)

 

nection, after which the Switch will close the connection. Any

 

numeric value between 0 and 160 is allowed, the factory default

 

is 5. A value of 0 disables the timeout.

Baud Rate

The default baud rate at which the serial port will try to connect.

 

This is selected from a pull-down menu. The available values are

 

1200, 2400, 4800, 9600, 19200, 38400,57600, and 115200 baud.

 

The factory Default is 9600 baud.

Character Size

The number of bits in a character. The number of bits is always 8.

Flow Control

Whether Hardware Flow-Control is enabled or disabled. Hard-

 

ware Flow Control is always disabled.

Stop Bits

The number of Stop bits per character. The number of Stop bits is

 

always 1.

Parity Type

The Parity Method used on the Serial Port. The Parity Method is

 

always None.

config serial baudrate

This command specifies the communication rate of the terminal interface. The supported rates are 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200.

Default

9600

Format

config serial baudrate <speed>

config serial timeout

This command specifies the maximum connect time (in minutes) without console activity. A value of 0 indicates that a console can be connected indefinitely. The time range is 0 to 160.

Default

5

Format

config serial timeout <0 - 160>

config snmpcommunity accessmode

This command restricts access to switch information. The access mode can be read-only (also called public) or read/write (also called private).

Format

config

snmpcommunity accessmode <rorw>

 

<name>

 

 

 

 

Switching Commands

 

7-17

Page 71
Image 71
NETGEAR L3 manual Config serial baudrate, Config serial timeout, Config snmpcommunity accessmode, 9600