7000 Series L3 Managed Switch Reference Manual for Software v2.0
7-82 Switching Commands
Format transfer upload datatype <config|error-
log|msglog|traplog>
The datatype is one of the following:
config Configuration file
errorlog Error log
msglog Message log
traplog Trap log (the default)
transfer upload start
This command starts an upload transfer after displaying current settings and upon confirmation.
Format transfer upload start
transfer download mode
This command specifies whether XMODEM or TFTP mode is used when uploading from the
switch.
Default xmodem. This is valid only when the transfer is initiated by the
serial EIA 232 port.
Format transfer download mode <xmodem|tftp>
transfer download serverip
This command configures the IP address of the server on which the file is located.
Note: This command is valid only when the transfer mode is TFTP. See “transfer download
mode” .
Default 0.0.0.0
Format transfer download serverip <ipAddr>
transfer download path
This command sets the directory path used to download the file. The switch “remembers” the last
file path used.