7000 Series L3 Managed Switch Reference Manual for Software v2.0

Management Commands

These commands manage the switch and show current management settings.

show network

This command displays network configuration settings that are vital for switch operation.

Format

show network

IP Address

The IP address of the interface. The factory default value is

 

0.0.0.0

Subnet Mask

The IP subnet mask for this interface. The factory default value is

 

0.0.0.0

Default Gateway

The default gateway for this IP interface. The factory default

 

value is 0.0.0.0

BurnedIn MAC Address

The burnedin MAC address used for in-band connectivity.

Network Configuration

Indicates which network protocol is being used. The options are

Protocol Current

 

bootpdhcpnone.

Web Mode

Specifies if the switch should allow access from a web browser.

 

Enabled means the switch can be managed from a web browser.

 

The factory default is enabled.

Java Mode

Specifies if the switch should allow access to the Java applet in

 

the header frame. Enabled means the applet can be viewed. The

 

factory default is enabled.

config network parms

This command sets the IP Address, subnet mask and gateway of the router. The IP Address and the gateway must be on the same subnet.

Format

config network parms <ipAddr> <netmask>

 

[gateway]

config network protocol

This command specifies the network configuration protocol to be used. If you modify this value change is effective immediately.(See “save config” on page 80.)

Switching Commands

7-15

Page 69
Image 69
NETGEAR L3 manual Management Commands, Show network, Config network parms, Config network protocol