NETGEAR L3 manual Config router ospf virtif delete, Config router ospf virtif authtypekey

7000 Series L3 Managed Switch Reference Manual for Software v2.0

config router ospf virtif delete

This command deletes the OSPF virtual interface from the given interface, identified by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of the neighbor.

Format config router ospf virtif delete <areaid> <neighbor>

config router ospf virtif authtypekey

This command configures the authentication type and key for the OSPF virtual interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of the neighbor. The value for <type> is either none or simple. The [key] is composed of standard displayable, non- control keystrokes from a Standard 101/102-key keyboard. The authentication key must be 8 bytes or less if the authentication type is simple password. If the key is cryptographic, the key may be up to 256 bytes. Unauthenticated interfaces do not need an authentication key.

Default	The default value for authentication type is none. The default
	password key is not configured.
Format	config router ospf virtif authtypekey <areaid> <neigh-
	bor> <nonesimple> [key]

config router ospf virtif transdelay

This command configures the transit delay for the OSPF virtual interface on the virtual interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of the neighbor. The range for <seconds> is 0 to 3600 (1 hour).

Default	1
Format	config router ospf virtif interval transdelay <areaid>
	<neighbor> <0-3600>

config router ospf virtif interval dead

This command configures the dead interval for the OSPF virtual interface on the virtual interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of the neighbor. The range for <seconds> is 1 to 65535.

Default	40
Format	config router ospf virtif interval dead <areaid>
	<neighbor> <1-65535>
Routing Commands	8-25