7000 Series L3 Managed Switch Reference Manual for Software v2.0

config garp jointimer

This command sets the GVRP join time per port and per GARP. Join time is the interval between the transmission of GARP Protocol Data Units (PDUs) registering (or re-registering) membership for a VLAN or multicast group.

This command has an effect only when GVRP is enabled. The time is from 10 to 100 (centiseconds)

Default

20 centiseconds (0.2 seconds)

Format

config garp jointimer <slot.port/all> <10-

 

100>

config garp leavetimer

This command sets the GVRP leave time per port. Leave time is the time to wait after receiving an unregister request for a VLAN or a multicast group before deleting the VLAN entry. This can be considered a buffer time for another station to assert registration for the same attribute in order to maintain uninterrupted service.time is 20 to 600 (centiseconds).

Note: This command has an effect only when GVRP is enabled.

Default

60 centiseconds (0.6 seconds)

Format

config garp leavetimer <slot.port/all> <20-

 

600>

config garp leavealltimer

This command sets how frequently Leave All PDUs are generated per port. A Leave All PDU indicates that all registrations will be unregistered. Participants would need to rejoin in order to maintain registration. The value applies per port and per GARP participation. The time may range from 200 to 6000 (centiseconds).

Note: This command has an effect only when GVRP is enabled.

Default

1000 centiseconds (10 seconds)

Format

config garp leavealltimer <slot.port/all>

 

<200-6000>

7-40

Switching Commands

Page 94
Image 94
NETGEAR L3 manual Config garp jointimer, Config garp leavetimer, Config garp leavealltimer