7000 Series L3 Managed Switch Reference Manual for Software v2.0

config spanningtree port mode

This command sets the Administrative Switch Port State to a new value for the specified port. The port <slot.port> is the desired switch port. To enable or disable all ports with a single command, "all" can be specified. Note that only 4095 ports can be enabled.

Default

disable

Format

config spanningtree port mode <slot.port/

 

all> <enable/disable>

show spanningtree bridge

This command displays spanning tree settings for the bridge.

Format

show spanningtree bridge

Bridge Priority

Configured value.

Bridge Identifier

 

Bridge Max Age

Configured value.

Bridge Hello Time

Configured value.

Bridge Forward Delay

Configured value.

Bridge Hold Time

Minimum time between transmission of Configuration Bridge

 

Protocol Data Units (BPDUs)

config spanningtree bridge maxage

This command sets the Bridge Max Age parameter to a new value for the common and internal spanning tree. The maxage <value> is in whole seconds within a range of 6 to 40, with the value being less than or equal to "2 times (Bridge Forward Delay - 1)".

Default

20

Format

config spanningtree bridge maxage <6-40>

config spanningtree bridge hellotime

This command sets the Hello Time parameter to a new value for the common and internal spanning tree. The hellotime <value> is in whole seconds within a range of 1 to 10 with the value being less than or equal to "(Bridge Max Age / 2) - 1".

Default

2

Format

config spanningtree bridge hellotime <1-10>

 

 

7-52

Switching Commands

Page 106
Image 106
NETGEAR L3 manual Config spanningtree port mode, Show spanningtree bridge, Config spanningtree bridge maxage