7000 Series L3 Managed Switch Reference Manual for Software v2.0

4.When the following screen appears, make sure that the port setting are as follows:

Baud Rate:

9600

Data Bits:

8

Parity:

None

Stop Bits:

1

Flow Control:

None

Figure 3-4: Connection Settings

5.Click OK.

The Hyper Terminal window will open and you should be connected to the switch. If you do not get a welcome screen or a system menu, hit the return key.

When attached to the User Interface via a Telnet Session, the following must be set in order to use the arrow keys: Under the terminal pull down menu choose Properties and make sure the VT100 Arrows option is turned on.

Introduction to the Command Menu Interface

The switch offers a Command Menu Interface (CMI), which is a menu-driven method for managing the switch, as well as a Command Line Interface (CLI), which uses text inputs to manage the switch. The CLI is accessed through the CMI, but is not addressed in this chapter. Chapter 5 discusses the CLI in detail.

Administration Console Telnet Interface

3-3

Page 29
Image 29
NETGEAR L3 manual Introduction to the Command Menu Interface, Connection Settings