7000 Series L3 Managed Switch Reference Manual for Software v2.0

save config

This command permanently saves configuration changes to Non-Volatile Random Access Memory (NVRAM).

Format

save config

logout

This command closes the current telnet connection or resets the current serial connection. Note: Save configuration changes before logging out. See “save config” .

Formatlogout

transfer upload mode

This command specifies whether XMODEM or TFTP mode is used when uploading from the switch.

Default

xmodem. This is valid only when the transfer is initiated by the

 

serial EIA 232 port.

Format

transfer upload mode <xmodemtftp>

transfer upload serverip

This command sets the IP address of the server on which the file is located.

Note: This command is valid only when the transfer mode is TFTP. See “transfer upload mode” .

Default

0.0.0.0

Format

transfer upload serverip <ipaddr>

transfer upload path

This command sets the directory path used to upload the file. The switch “remembers” the last file path used.

Note: This command is valid only when the transfer mode is TFTP. See “transfer upload mode” .

7000 Series L3 Managed Switch Software supports TFTP client. The TFTP client path statement requirement is sever dependent. A path statement is generally required to setup the TFTP client; however, the client path may remain blank.

7-80

Switching Commands

Page 134
Image 134
NETGEAR L3 manual Save config, Logout, Transfer upload mode, Transfer upload serverip, Transfer upload path