7000 Series L3 Managed Switch Reference Manual for Software v2.0

config spanningtree configuration revision

This command sets the Configuration Identifier Revision Level for use in identifying the configuration that this switch is currently using. The <revision> is a number in the range of 0 to 65535.

Default

0

Format

config spanningtree configuration revision

 

<0-65535>

show spanningtree port

This command displays the settings and parameters for a specific switch port within the common and internal spanning tree. The <slot.port> is the desired switch port.

Format

show spanningtree port <slot.port>

Port mode

Enabled or disabled.

Port Up Time Since

Time since port was reset, displayed in days, hours, minutes, and

Counters Last Cleared

 

seconds.

STP BPDUs Transmitted

Spanning Tree Protocol Bridge Protocol Data Units sent

STP BPDUs Received

Spanning Tree Protocol Bridge Protocol Data Units received.

RST BPDUs Transmitted

Rapid Spanning Tree Protocol Bridge Protocol Data Units sent

RST BPDUs Received

Rapid Spanning Tree Protocol Bridge Protocol Data Units

 

received.

MSTP BPDUs Transmitted

Multiple Spanning Tree Protocol Bridge Protocol Data Units sent

MSTP BPDUs Received

Multiple Spanning Tree Protocol Bridge Protocol Data Units

 

received.

config spanningtree port bpdumigrationcheck

This command forces the specified port to transmit RST or MST BPDUs. The port <slot.port> is the desired switch port. To set the migration check for all ports with a single command, "all" can be specified. Note that the forceversion parameter for the switch must be set to 802.1w or 802.1s.

Default

disable

Format

config spanningtree port bpdumigrationcheck

 

<slot.port/all> <enable/disable>

Switching Commands

7-51

Page 105
Image 105
NETGEAR L3 Config spanningtree configuration revision, Show spanningtree port, Config spanningtree port bpdumigrationcheck