7000 Series L3 Managed Switch Reference Manual for Software v2.0

config radius server remove

This command removes the configured RADIUS server. The specified IP address must match that of a previously configured RADIUS server. When a server is removed all configuration for the server is erased including the shared secret. If the removed server was the primary server, one of the remaining configured servers will be used as the RADIUS server for future RADIUS requests.

Format

config radius server remove <ipaddr>

config radius server secret

This command configures on the client the shared secret between the RADIUS client and the RADIUS server. Each configured server requires a secret to be configured. The server is specified by the IP address. When this command is issued, the secret will be prompted. The secret must be an alphanumeric value of 20 characters or less.

Format

config radius server secret <ipaddr>

config radius server primary

This command specifies which configured server should be the primary server for this RADIUS client. The primary is the server that is used by default for handling RADIUS requests. The remaining configured servers are used only if the primary server cannot be reached. A maximum of three servers can be configured on each client. Only one server can be configured as the primary server. If a primary server is currently configured and this command is issued, the server specified by the IP address used in this command will become the new primary server. The IP address specified must match that of a configured server.

Format

config radius server primary <ipaddr>

config radius server msgauth

This command enables or disables the message authenticator attribute for the specified RADIUS server. Enabling the message authenticator attribute provides additional security in the connection between the RADIUS client and the RADIUS server. Some RADIUS servers require the enablement of the message authenticator attribute for authentication requests from the RADIUS client to be accepted. The IP address specified must match that of a configured server.

Format

config radius server msgauth <ipaddr> <enable/dis-

 

able>

7-66

Switching Commands

Page 120
Image 120
NETGEAR L3 manual Config radius server remove, Config radius server secret, Config radius server primary