7000 Series L3 Managed Switch Reference Manual for Software v2.0

config router ospf interface interval hello

This command sets the OSPF hello interval for the specified interface.

The value for <seconds> is a valid positive integer, which represents the length of time in seconds. The value for the length of time must be the same for all routers attached to a network.

Valid values range from 1 to 65535.

Default

10

Format

config router ospf interface interval hello

 

<slot.port> <1-65535>

config router ospf interface interval retransmit

This command sets the OSPF retransmit Interval for the specified interface.

The value for <seconds> is the number of seconds between link-state advertisement retransmissions for adjacencies belonging to this router interface. This value is also used when retransmitting database descriptions and link-state request packets.

Valid values range from 0 to 3600 (1 hour).

Default

5

Format

config router ospf interface interval

 

retransmit <slot.port> <0-3600>

config router ospf interface iftransitdelay

This command sets the OSPF Transit Delay for the specified interface. In addition, it sets the estimated number of seconds it takes to transmit a link state update packet over this interface.

Valid values for <seconds> range from 1 to 3600 (1 hour).

Default

1

Format

config router ospf interface iftransitdelay

 

<slot.port> <1-3600>

config router ospf interface mode

This command enables or disables OSPF on a router interface.

Routing Commands

8-13

Page 153
Image 153
NETGEAR L3 manual Config router ospf interface interval hello, Config router ospf interface interval retransmit