NETGEAR L3 manual Show router ospf stub table, Show router ospf lsdb summary

	7000 Series L3 Managed Switch Reference Manual for Software v2.0
Router ID	Is 4 digit dotted decimal number representing the neighbor inter-
	face.
IP Address	Is an IP address representing the neighbor interface.
Neighbor Interface Index	Is a slot.port identifying the neighbor interface index.

show router ospf stub table

This command displays the OSPF stub table. The information below will only be displayed if OSPF is initialized on the switch.

Format	show router ospf stub table
Area ID	Is a 32-bit identifier for the created stub area.
Type of Service	Is the type of service associated with the stub metric. The
	GSM73xx L3 Switch only supports Normal TOS.
Metric Val	The metric value is applied based on the TOS. It defaults to the
	least metric of the type of service among the interfaces to other
	areas. The OSPF cost for a route is a function of the metric value.
Metric Type	Is the type of metric advertised as the default route.
Import Summary LSA	Controls the import of summary LSAs into stub areas.

show router ospf lsdb summary

This command displays the link state database. This command takes no options. The information below will only be displayed if OSPF is enabled.

Format	show router ospf lsdb summary
Router ID	Is a 32 bit dotted decimal number representing the LSDB inter-
	face.
Area ID	Is the IP address identifying the router ID.
LSA Type	The types are: router, network, ipnet sum, asbr sum, as external,
	group member, tmp 1, tmp 2, opaque link, opaque area.
LS ID	Is a number that "uniquely identifies an LSA that a router origi-
	nates from all other self originated LSA's of the same LS type."
Age	Is a number representing the age of the link state advertisement in
	seconds.
Sequence	Is a number that represents which LSA is more recent.
Checksum	Is to total number LSA checksum.
Options	This is an integer. It indicates that the LSA receives special han-
	dling during routing calculations.
Routing Commands	8-19