NETGEAR L3 manual Config diffserv class match dstl4port range, Config diffserv class match dstmac

7000 Series L3 Managed Switch Reference Manual for Software v2.0

config diffserv class match dstl4port range

This command adds to the specified class definition a match condition based on the destination layer 4 port of a packet using a numeric range notation. The <classname> is the name of an existing DiffServ class. Two layer 4 port numbers are required and together they specify a contiguous port range. Each port number is an integer from 0 to 65535, but with the added requirement that the second number be equal to or greater than the first. The optional [exclude] parameter has the effect of negating this match condition for the class (i.e., match all destination layer 4 port numbers except for those within the range specified here).

Note: The dstl4port keyword, number, and range commands are alternative ways to specify a destination layer 4 port range as a match criterion.

Default	none
Format	config diffserv class match dstl4port range <class-
	name> <0-65535> <0-65535> [exclude]

config diffserv class match dstmac

This command adds to the specified class definition a match condition based on the destination MAC address of a packet. The <classname> is the name of an existing DiffServ class. The <macaddr> parameter is any layer 2 MAC address formatted as six, two-digit hexadecimal numbers separated by colons (e.g., 00:11:22:dd:ee:ff). The <macmask> parameter is a layer 2 MAC address bit mask, which need not be contiguous, and is formatted as six, two-digit hexadecimal numbers separated by colons (e.g., ff:07:23:ff:fe:dc). The optional [exclude] parameter has the effect of negating this match condition for the class (i.e., match all destination MAC addresses except for what is specified here).

Default	none
Format	config diffserv class match dstmac <classname> <mac-
	addr> <macmask> [exclude]

config diffserv class match every

This command adds to the specified class definition a match condition whereby all packets are considered to belong to the class. The <classname> is the name of an existing DiffServ class. The optional [exclude] parameter has the effect of negating this match condition for the class (i.e., none of the packets are considered to belong to the class).

CLI Commands: Differentiated Services 9-7