NETGEAR L3 manual Config router rip preference, Config router rip interface authtypekey

7000 Series L3 Managed Switch Reference Manual for Software v2.0

config router rip preference

This command sets the route preference value of RIP in the router. Lower route preference values are preferred when determining the best route.

Default	15
Format	config router rip preference <0-255>

config router rip interface authtypekey

This command sets the RIP Version 2 Authentication Type and Key for the specified interface. The value of <type> is either none or simple.

The value for authentication key [key] must be 16 bytes or less. The [key] is composed of standard displayable, non-control keystrokes from a Standard 101/102-key keyboard.

Default	The default authentication type is none.
Default	The default password key is an empty string. Unauthenticated
	interfaces do not need an authentication key.
Format	config router rip interface authtypekey
	<slot.port> <nonesimple> [key]

config router rip interface defaultmetric

This command specifies the metric value that is to be used for the default route entry (0.0.0.0 with subnet mask = 0.0.0.0) in RIP updates originating from this interface.Valid values for <metric> range from 0 to 15.

Note that a metric value of 0 suppresses default route originations (although a default route may be propagated on this interface from another router). A metric value of 1 instructs the router to always advertise a default route entry with a metric of 1 in its route update messages, which could adversely affect network operation.

Default	0.
Format	config router rip interface defaultmetric
	<slot.port> <0-15>

8-22 Routing Commands