7000 Series L3 Managed Switch Reference Manual for Software v2.0

show port

This command displays port information.

Format

show port <slot.portall>

Slot.Port

The physical slot and physical port.

Type

If not blank, this field indicates that this port is a special type of

 

port. The possible values are:

 

Mon - this port is a monitoring port. Look at the Port Monitoring

 

screens to find out more information.

 

Lag - this port is a member of a Lag. Look at the Lag screens to

 

find out more information.

 

Probe - this port is a probe port. Look at the Port Mirroring

 

screens to find out more information.

Admin Mode

Selects the Port control administration state. The port must be

 

enabled in order for it to be allowed into the network. - May be

 

enabled or disabled by selecting the corresponding line on the

 

pull-down entry field. The factory default is enabled.

Physical Mode

Selects the desired port speed and duplex mode. If auto-negotia-

 

tion support is selected, then the duplex mode and speed will be

 

set from the auto-negotiation process. Note that the port's maxi-

 

mum capability (full duplex -100M) will be advertised. Other-

 

wise, this object will determine the port's duplex mode and

 

transmission rate. The factory default is Auto.

Physical Status

Indicates the port speed and duplex mode.

Link Status

Indicates whether the Link is up or down.

Link Trap

This object determines whether or not to send a trap when link

 

status changes. The factory default is enabled.

LACP Mode

Displays whether LACP is enabled or disabled on this port.

config port adminmode

This command enables or disables a port.

Default

enable

port adminmode <slot.portall>

Format

config

 

<enabledisable>

7-26

Switching Commands

Page 80
Image 80
NETGEAR L3 manual Show port, Config port adminmode