NETGEAR L3 manual Service Commands, Config diffserv policy shape peak, Applied, Expedite all forms

	7000 Series L3 Managed Switch Reference Manual for Software v2.0
Restrictions	This shaping rate must not exceed the maximum link data rate of
	the interface to which the policy is applied.
Policy Type	Out

config diffserv policy shape peak

This command is used to establish peak rate traffic shaping for the specified class, which allows transmissions for the class to exceed the committed information rate by sending excess traffic with the understanding that it could be dropped by a downstream network element. The <policyname> and <classname> are the names of an existing DiffServ policy and class, respectively. Two rate parameters are used, a committed information rate and a peak information rate. Each of these rates is specified in kilobits-per-second (Kbps) and is an integer from 1 to 4294967295. The peak rate must be specified as equal to or greater than the committed rate.

Note: Queue depth management defaults to tail drop, but the config diffserv policy randomdrop command can be used to change to a RED scheme.

Format	config diffserv policy shape peak <policyname> <class-
	name> <1-4294967295> <1-4294967295>
Restrictions	Neither of the shaping rate parameters is allowed to exceed the
	maximum link data rate of the interface to which the policy is
	applied.
Policy Type	Out
Incompatibilities	Expedite (all forms)

Service Commands

The 'service' command set is used in DiffServ to define:

Traffic Conditioning	Assign a DiffServ traffic conditioning policy (as specified by the
	policy commands) to an interface in the incoming direction
Service Provisioning	Assign a DiffServ service provisioning policy (as specified by the
	policy commands) to an interface in the outgoing direction

The service commands attach a defined policy to a directional interface. Only one policy may be assigned at any one time to an interface in a particular direction. The policy type (in, out) must match the interface direction to which it is attached.

CLI Commands: Differentiated Services 9-27