7000 Series L3 Managed Switch Reference Manual for Software v2.0

config igmpsnooping groupmembershipinterval

This command sets the IGMP Group Membership Interval time on the system. The Group Membership Interval time is the amount of time in seconds that a switch will wait for a report from a particular group on a particular interface before deleting the interface from the entry. This value must be greater than the IGMP Maximum Response time value. The range is 1 to 3600 seconds.

Default

260 seconds

Format

config igmpsnooping groupmembershipinterval <1-3600>

config igmpsnooping maxresponse

This command sets the IGMP Maximum Response time on the system. The Maximum Response time is the amount of time in seconds that a switch will wait after sending a query on an interface because it did not receive a report for a particular group in that interface. This value must be less than the IGMP Query Interval time value. The range is 1 to 3600 seconds.

Default

10 seconds

Format

config igmpsnooping maxresponse <1-3600>

config igmpsnooping mcrtrexpiretime

This command sets the Multicast Router Present Expiration time on the system. This is the amount of time in seconds that a switch will wait for a query to be received on an interface before the interface is removed from the list of interfaces with multicast routers attached. The range is 0 to 3600 seconds. A value of 0 indicates an infinite timeout, i.e. no expiration.

Default

0

Format

config igmpsnooping mcrtrexpiretime <0-3600>

config igmpsnooping interface mode

This command enables or disables IGMP Snooping on a selected interface. The <slot.port/all> parameter identifies the interface on which to configure the mode. If an interface which has IGMP Snooping enabled is enabled for routing or is enlisted as a member of a LAG, IGMP Snooping functionality will be disabled on that interface. IGMP Snooping functionality will subsequently be re-enabled if routing is disabled or LAG membership is removed from an interface that has IGMP Snooping enabled.

Defaultdisable

7-42

Switching Commands

Page 96
Image 96
NETGEAR L3 manual Config igmpsnooping groupmembershipinterval, Config igmpsnooping maxresponse, Seconds