7000 Series L3 Managed Switch Reference Manual for Software v2.0

 

 

 

 

Table 6-3.

Quick Start Up User Account Management

 

 

 

 

Command

 

Details

 

 

 

 

config users passwd <user>

Allows the user to set passwords or change passwords needed to

 

 

 

log in.

 

 

 

A prompt will appear after the command is entered requesting the

 

 

 

users old password. In the absence of an old password leave the

 

 

 

area blank. The operator must press enter to execute the

 

 

 

command.

 

 

 

The system then prompts the user for a new password then a

 

 

 

prompt to confirm the new password. If the new password and the

 

 

 

confirmed password match a message will be displayed

 

save config

 

This will save passwords and all other changes to the device.

 

 

 

If you do not save config, all configurations will be lost when a

 

 

 

power cycle is performed on the switch or when the switch is reset

 

 

 

 

 

logout

 

Logs the user out of the switch

 

IP Address

To view the network parameters the operator can access the device by the following three methods.

Simple Network Management Protocol - SNMP

Telnet

Web Browser

Note: Helpful Hint: The user should do a save config after configuring the network parameters so that the configurations are not lost

Table 6-4. Quick Start Up IP Address

Command

Details

 

 

 

 

show network

Displays the Network Configurations

 

 

IP Address - IP Address of the interface

 

 

Default IP is 0.0.0.0

 

 

 

 

 

Subnet Mask - IP Subnet Mask for the interface

 

 

Default is 0.0.0.0

 

 

 

 

 

Default Gateway - The default Gateway for this interface

 

 

Default value is 0.0.0.0

 

 

 

 

 

 

 

Quick Startup

6-3

Page 45
Image 45
NETGEAR L3 manual IP Address, Config users passwd user