OPTIONAL CONTROLS
See Figures 1 and 6.
Cutting Height – Swivel Models
CAUTION: On swivel wheel models, when mowing on slopes it is recommended that the linchpin be positioned through the swivel lock hole. If wheels are in the swivel position and control handles are released the mower may “free roll” downhill. Never mow on steep slopes.
To change front wheel cutting height, insert clevis pin into the holes that correspond to the
desired cutting height. (Figure 6).
To change rear wheel cutting height, move cutting height levers one notch at a time until the desired cutting height is obtained. (Figure 6).
Primer Bulb (Briggs & Stratton Engine)
Push the Primer Bulb in to add fuel for easier engine start.
Primer Bulb
OM0570
Figure 7
Throttle/Choke (Robin Engine)
The Throttle controls the engine speed and chokes engine for starting.
Speed Selector
Speed Selector is used to select variable forward travel speeds of mower.
High
OM0480 Low
With Speed Selector set at a slow travel speed and engine running, engage Wheel Drive Control. Increase speed with Speed Selector to a safe, comfortable walking pace. Once speed has been selected, Speed Selector should remain in this position. If not, adjust speed control bell crank spring tension. (See Adjustments).
Wheel Drive Control
CAUTION: Holding Wheel Drive control of
With engine running, slowly squeeze and hold Wheel Drive Control against handlebar to propel mower forward. Release Wheel Drive Control to stop forward motion.
Ignition Switch (electric start models)
The Ignition Switch is operated by
1a removable Key. To start the unit, the switch is turned clockwise from the "RUN" position to the "START" position. The key will
2spring back to the "RUN" position.
RUN Position (1): All controls are
operable.
OM1000 START Position (2): Starter turns
over the engine.
GB - 11
