Husqvarna 580 R, 580 RS, 580 RSE, 580 RSW, 600 C owner manual Engine/Blade Control, No slack

3.Charge for 24 to 48 hours (battery may be charged for up to 72 hours with no harmful effects).

An engine run time of at least 8 hours is required to charge a fully discharged battery.

To Remove Battery from Unit

1.Remove wing nuts from battery U-bolt.

2.Disconnect battery from wiring.

ENGINE/BLADE CONTROL

To adjust engine/blade control:

1. Loosen cable nuts away from bracket.

Figure 16

2.Squeeze z-bend bracket at engine end of cable toward front of unit and hold in place.

No slack

4.Tighten lower

cable nut to 1/1/8”

8" (3mm)(3mm) below bracket.

Release z- bend bracket.

5.Tighten upper

cable nut until

bracket is secure between cable

nuts.

6.Engage engine/blade control. Measure distance between middle of z-bend and cable bracket. Measurement should be as shown below.

1.325"-1.788" (3.4 - 4.5 cm)

Briggs & Stratton

Robin

Briggs & Stratton

Robin

1.240" (3.15 cm)

7. If proper measurement cannot be achieved, contact your local dealer.

3.Pull cable down from bracket until there is no slack in cable.

GB - 19