CHECK DRIVE BELT
| 1 |
| 2 |
4 |
|
3 | OM0250 |
| |
1. | Blade |
2. | Cap Screw, Lock |
| Washer & Flat Washer |
3. | Drive Belt |
4. | Idler |
| Figure 11 |
Check drive belt for wear or damage. Replace belt if worn or damaged. See Service and Adjustments.
CHECK ENGINE/BLADE
CONTROL
The engine/blade control must stop the engine and blade within 3 seconds after the bail is released. If the engine or blade continues to run, adjust or repair control immediately. See Adjustments.
CHECK GRASS BAG
Check bag for wear or damage. Keep bag clean and dry. Replace only with Husqvarna original equipment replacement bag.
CHECK DRIVE CONTROL (Self
propelled units)
Check operation of drive control. The drive must disengage completely when the bail handle is released. Adjust bail travel if necessary. See Adjustments.
GENERAL LUBRICATION
Mower does not require any lubrication. Wheel assemblies are designed for long life without additional lubrication.
NOTE: The 600C does have lube fittings on drive mount for use in commercial applications. Lubricate as needed.
Swivel Lubrication (swivel units)
See Figure 12.
When lubricating for the first time, clean all components thoroughly before applying grease. Reapply grease to the lube fittings every 25 hours.
NOTE: Linchpin must be in the swivel lock hole while lubricating.
2
1
1. Grease Fitting | OM0180 |
|
2.Swivel Lock Hole Figure 12
CHECK FASTENERS
Check all fasteners for proper tightness. Pay special attention to blade hardware and all guards, shields and safety devices.
CHECK SPARK PLUG
Spark plug should be cleaned (or replaced) if necessary and gap reset to .030" every 100 hours of operation or yearly, whichever comes first.
To clean:
1.Remove debris from area around spark plug base.
2.Remove spark plug from engine.
3.Scrape and wash spark plug with a commercial solvent. DO NOT blast clean.
4.Replace spark plug.
NOTE: Sparking can occur if wire terminal does not fit firmly on spark plug. Replace terminal if damaged.
GB - 16
