Cisco Systems A9014CFD Mac-addresstarget-address-Specifies, Mac-addresssource-address-Specifies

Chapter 11 ITU-T Y.1731 Performance Monitoring

		How to Configure ITU-T Y.1731 Performance Monitoring
	Command	Purpose
Step 5
	ethernet y1731 loss SLM domain domain-name{evc	Configures a single-ended synthetic loss
	evc-id vlan vlan-id} {mpid target-mp-id	measurement and enters IP SLA Y.1731 loss
	mac-address target-address}cos cos {source {mpid	configuration mode.
	source-mp-id mac-addresssource-address}}
		• SLM—Specifies that the frames sent are
	Example:	Synthetic Loss Measurement (SLM) frames.
		• domain domain-name—Specifies the name of
	Router(config-ip-sla)# ethernet y1731 loss SLM
	domain xxx evc yyy mpid 101 cos 4 source mpid 100	the Ethernet Connectivity Fault Management
		(CFM) maintenance domain.
		• evc evc-id—Specifies the EVC identification
		name.
		• vlan vlan-id—Specifies the VLAN identification
		number. The range is from 1 to 4096.
		• mpid target-mp-id—Specifies the maintenance
		endpoint identification numbers of the MEP at
		the destination. The range is from 1 to 8191.
		• mac-addresstarget-address—Specifies the
		MAC address of the MEP at the destination.
		• cos cos—Specifies, for this MEP, the class of
		service (CoS) that will be sent in the Ethernet
		message. The range is from 0 to 7.
		• source—Specifies the source MP ID or MAC
		address.
		• mpid source-mp-id—Specifies the maintenance
		endpoint identification numbers of the MEP
		being configured. The range is from 1 to 8191.
		• mac-addresssource-address—Specifies the
		MAC address of the MEP being configured.
Step 6
	aggregate interval seconds	(Optional) Configures the length of time during
		which the performance measurements are conducted
	Example:	and the results stored.
	Router(config-sla-y1731-loss)# aggregate interval	• seconds—Specifies the length of time in seconds.
	900	The range is from 1 to 65535. The default is 900.
Step 7
	availability algorithm {sliding-window	(Optional) Specifies availability algorithm used.
	static-window}	• sliding-window—Specifies a sliding-window
	Example:	control algorithm.
		• static-window—Specifies static-window control
	Router(config-sla-y1731-loss)# availability
		algorithm.
	algorithm static-window
Step 8
	frame consecutive value	(Optional) Specifies number of consecutive
		measurements to be used to determine availability or
	Example:	unavailability status.
	Router(config-sla-y1731-loss)# frame consecutive 10	• value—Specifies the number of consecutive
		measurements. The range is from 1 to 10. The
		default is 10.
	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09			11-11