Cisco Systems A9014CFD Configuring Mpls Exp Bit Marking using a Pseudowire, Specify an EVC, 24-41

Chapter 24 Configuring QoS

Configuring Quality of Service (QoS)

Step 5 Use the service-policycommand to attach the policy map to an interface. The input and output parameters specify the direction in which router applies the policy map.

Router(config-if)# service-policy input policy1

Step 6 Exit configuration mode.

Router(config-cmap)# end

Router#

Note You can use the show policy map interface command to verify your configuration.

Configuring MPLS Exp Bit Marking using a Pseudowire

You can also configure MPLS Exp bit marking within an EoMPLS pseudowire interface using the set mpls experimental imposition command. MQC based policy configuration supersedes pseudowire-class mode of configuring QoS marking. The MQC policy shall contain only class-default with set action to achieve the same. Follow these steps to configure MPLS Exp bit marking using a pseudowire interface.

Complete the following steps to apply a marking policy to a pseudowire:

Step 1 Enter the interface configuration mode.

Router(config)# interface gigabitethernet 0/0

Router(config-if)#

Step 2 Specify an EVC.

Router(config-if)# service instance 1 ethernet

Router(cfg-if-srv)#

Step 3 Specify an encapsulation type for the EVC.

Router(cfg-if-srv)# encapsulation dot1q 200

Step 4 Use the xconnect command with the service policy that uses the configuration defined in the pseudowire class.

Router(cfg-if-srv)# xconnect 10.10.10.1 121

Router(cfg-if-srv)# service-policy in <mark-policy>

For more information about configuring marking, see the Cisco IOS Quality of Service Solutions Configuration Guide, Release 12.2SR.

Note The Cisco ASR 901 does not support all of the commands described in the IOS Release 12.2SR documentation.

Configuration Example

This is a sample configuration example for applying a marking policy to a pseudowire.

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		24-41