Cisco Systems A9014CFD Command, Notification-type -snmp authentication -Enables RFC, Temperature

Chapter 4 Managing and Monitoring Network Management Features

How to Configure Network Management Features on ASR 901

	Command	Purpose
Step 5 Router(config)# snmp-server enable		Enables the router to send SNMP traps messages. Use the no form of this
	traps [notification-type]	command to disable SNMP notifications.
	[notification-option]	• notification-type—snmp [authentication]—Enables RFC 1157
	Example:	SNMP notifications. Note that use of the authentication keyword
		produces the same effect as not using the authentication keyword.
	Router(config)# snmp-server enable
		Both the snmp-server enable traps snmp and snmp-server enable
	traps snmp linkdown linkup
		traps snmp authentication forms of this command globally enable
	coldstart warmstart
		(or, if using the no form, disable) the following SNMP traps:
		–	authentication failure
		–	linkup
		–	linkdown
		–	coldstart
		–	warmstart
		• notification-option—(Optional)atm pvc [interval seconds]
		[fail-intervalseconds]—The optional interval seconds
		keyword/argument combination specifies the minimum period
		between successive traps, in the range from 1 to 3600. Generation of
		PVC traps is dampened by the notification interval to prevent trap
		storms. No traps are sent until the interval lapses. The default interval
		is 30.
		The optional fail-interval seconds keyword/argument combination
		specifies the minimum period for storing the failed time stamp, in the
		range from 0 to 3600. The default fail-interval is 0.
		• envmon [voltage shutdown supply fan temperature]—When
		the envmon keyword is used, you can enable a specific environmental
		notification type, or accept all notification types from the
		environmental monitor system. If no option is specified, all
		environmental notifications are enabled. The option can be one or
		more of the following keywords: voltage, shutdown, supply, fan,
		and temperature.
		• isdn [call-information isdn u-interface]—When the isdn keyword
		is used, you can specify the call-informationkeyword to enable an
		SNMP ISDN call information notification for the ISDN MIB
		subsystem, or you can specify the isdnu-interfacekeyword to enable
		an SNMP ISDN U interface notification for the ISDN U interface
		MIB subsystem.
		• repeater [health reset]—When the repeater keyword is used, you
		can specify a repeater option. If no option is specified, all repeater
		notifications are enabled. The option can be one or more of the
		following keywords:
		– health—Enables IETF Repeater Hub MIB (RFC 1516) health
			notification.
		– reset—Enables IETF Repeater Hub MIB (RFC 1516) reset
			notification.

Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide

OL-23826-09 4-5