Cisco Systems A9014CFD manual Sla, Xlix

Chapter

Chapter	Description
Chapter 21, “Configuring	Describes how to configure pseudowire on the router.
Pseudowire”
Chapter 22, “Configuring	Describes how to configure clocking on the router.
Clocking”
Chapter 23, “Cisco IOS IP	Describes the IPSLA aspects of the router.
SLA”
Chapter 24, “Configuring	Describes how to configure QoS on the router.
QoS”
Chapter 25, “Configuring	Describes how to configure MLPPP on the router.
MLPPP”
Chapter 26, “Onboard Failure	Describes how to configure OBFL on the router.
Logging”
Chapter 27, “Hot Standby	Describes how to configure HSRP and VSRP.
Router Protocol and Virtual
Router Redundancy Protocol”
Chapter 28, “Configuring Link	Describes how to configure LLDP.
Layer Discovery Protocol”
Chapter 29, “Configuring	Describes how to configure multihop BFD
Multihop Bidirectional
Forwarding Detection”
Chapter 30, “Bit Error Rate	Describes how to configure Bit Error Rate testing.
Testing”
Chapter 31, “Microwave ACM	Describes how the Microwave Adaptive Code Modulation (ACM)
Signaling and EEM	Signaling and Embedded Event Manager (EEM) integration that
Integration”	enables the microwave radio transceivers to report link bandwidth
	information to an upstream Ethernet switch and take action on the
	signal degradation to provide optimal bandwidth.
Chapter 32, “IPv6 Support on	Describes how to support Long Term Evolution (LTE) rollouts that
the Cisco ASR 901 Router”	provides high-bandwidth data connection for mobile wireless
	devices.
Chapter 33, “Labeled BGP	Describes how to add label mapping information to the Border
Support”	Gateway Protocol
Chapter 34, “MPLS Traffic	Describes how to add Fast Reroute (FRR) link protection and
Engineering - Fast Reroute	Bidirectional Forwarding Detection (BFD)-triggered FRR feature of
Link Protection”	Multiprotocol Label Switching (MPLS) traffic engineering (TE).
Chapter 35, “Layer 2 Control	Describes how to configure Layer 2 (L2) Control Protocol Peering,
Protocol Peering, Forwarding,	Forwarding, and Tunneling feature on the Cisco ASR 901 Series
and Tunneling”	Aggregation Services Routers.
Chapter 36, “Configuring	Describes how to configure Inverse Multiplexing over ATM (IMA)
Inverse Muliplexing over	technology that is used to transport ATM traffic over a bundle of T1
ATM”	or E1 cables, known as IMA group in the Cisco ASR 901 Series
	Aggregation Services Routers.

Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide

OL-23826-09 -xlix