Cisco Systems A9014CFD manual Configuring ATM/IMA Pseudowire Redundancy in PVP Mode, 21-24

Chapter 21 Configuring Pseudowire

Configuring Hot Standby Pseudowire Support for ATM/IMA

Configuring ATM/IMA Pseudowire Redundancy in PVP Mode

Complete the following steps to configure pseudowire redundancy in permanent virtual path (PVP) mode.

SUMMARY STEPS

1.enable

2.configure terminal

3.interface interface-name

4.atm pvp vpi l2transport

5.xconnect peer-ip-addressvc-idencapsulation mpls

6.backup peer peer-router-ip-addr vcid

DETAILED STEPS

	Command	Purpose
Step 1	enable	Enables privileged EXEC mode.
		• Enter your password if prompted.
	Example:
	Router> enable
Step 2
	configure terminal	Enters global configuration mode.
	Example:
	Router# configure terminal
Step 3
	interface interface-name	Selects the interface.
		• interface-name—Name of the interface
	Example:
	Router(config)# interface ATM0/IMA1
Step 4
	atm pvp vpi l2transport	Creates a permanent virtual path (PVP) used to multiplex (or bundle) one
		or more virtual circuits (VCs).
	Example:	• vpi—ATM network virtual path identifier (VPI) of the VC to
	Router(config-if)# atm pvp 90	multiplex on the permanent virtual path.

l2transport

•l2transport—Specifies that the PVP is for the Any Transport over MPLS (AToM) ATM cell relay feature or the ATM Cell Relay over L2TPv3 feature.

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
21-24	OL-23826-09