Cisco Systems A9014CFD Optional Set the interval at which continuity check, Is 10 seconds, Mode

Chapter 10 Configuring Ethernet OAM

	Command	Purpose
Step 10
	continuity-check interval value	(Optional) Set the interval at which continuity check
		messages are sent. The available values are 100 ms,
		1 second, 10 seconds, 1 minute and 10 minutes. The default
		is 10 seconds.
		Note Because faster CCM rates are more CPU-intensive,
		we do not recommend configuring a large number
		of MEPs running at 100 ms intervals.
Step 11
	continuity-check loss-threshold threshold-value	(Optional) Set the number of continuity check messages to
		be missed before declaring that an MEP is down. The range
		is 2 to 255; the default is 3.
Step 12
	maximum meps value	(Optional) Configure the maximum number of MEPs
		allowed across the network. The range is from 1 to 65535.
		The default is 100.
Step 13
	sender-id {chassis none}	(Optional) Include the sender ID TLVs, attributes
		containing type, length, and values for neighbor devices.
		• chassis—Send the chassis ID (host name).
		• none—Do not include information in the sender ID.
Step 14
	mip auto-create [lower-mep-only none]	(Optional) Configure auto creation of MIPs for the service.
		• lower-mep-only—Create a MIP only if there is a MEP
		for the service in another domain at the next lower
		active level.
		• none —No MIP auto-create.
Step 15
	exit	Return to ethernet-cfm configuration mode.
Step 16
	mip auto-create [lower-mep-only]	(Optional) Configure auto creation of MIPs for the domain.
		• lower-mep-only—Create a MIP only if there is a MEP
		for the service in another domain at the next lower
		active level.
Step 17
	mep archive-hold-time minutes	(Optional) Set the number of minutes that data from a
		missing maintenance end point is kept before it is purged.
		The range is 1 to 65535; the default is 100 minutes.
Step 18
	exit	Return to global configuration mode.
Step 19
	interface interface-id	Specify an interface to configure, and enter interface
		configuration mode.
Step 20
	service instance number ethernet name	Specify the service instance number and the name of the
		EVC.
Step 21
	cfm mip level level-id	(Optional) Configure a customer level or service-provider
		level maintenance intermediate point (MIP) for the
		interface. The MIP level range is 0 to 7.
		Note This step is not required if you have entered the
		ethernet cfm mip auto-create global
		configuration command or the mip auto-create
		ethernet-cfm or ethernet-cfm-srv configuration
		mode.
	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09			10-5