Cisco Systems A9014CFD manual 31-6

Chapter 31 Microwave ACM Signaling and EEM Integration

How to Configure Microwave ACM Signaling and EEM Integration

	Command	Purpose
Step 8	exit	Exits Ethernet EVC configuration mode and enters global
		configuration mode.
	Example:
	Router(config-evc)# exit
Step 9	interface type number	Specifies an interface type and number, and enters interface
		configuration mode.
	Example:
	Router(config)# interface
	GigabitEthernet0/11
Step 10	service instance id ethernet	Configures an Ethernet service instance on an interface.
		• id—Integer that uniquely identifies a service instance on an
	Example:	interface.
	Router(config-if)# service instance 60
	ethernet 60
Step 11	encapsulation dot1q vlan-id	Enables IEEE 802.1Q encapsulation of traffic on a specified
		interface in a VLAN.
	Example:	• vlan-id—Virtual LAN identifier.
	Router(config-if)# encapsulation dot1q
	60
Step 12	rewrite ingress tag pop 1 symmetric	Specifies the encapsulation adjustment to be performed on a frame
		ingressing a service instance.
	Example:	• pop—Removes a tag from a packet.
	Router(config-if)# rewrite ingress tag	• 1—Specifies the outermost tag for removal from a packet.
	pop 1 symmetric
		• symmetric—Indicates a reciprocal adjustment to be done in the
		egress direction. For example, if the ingress pops a tag, the
		egress pushes a tag and if the ingress pushes a tag, the egress
		pops a tag.
Step 13	bridge-domainbridge-domain-id	Enables RFC 1483 ATM bridging or RFC 1490 Frame Relay
		bridging to map a bridged VLAN to an ATM permanent virtual
	Example:	circuit (PVC) or Frame Relay data-link connection identifier
		(DLCI).
	Router(config-if)# bridge-domain 60
		• bridge-domain-id—Bridge domain identifier.
Step 14	exit	Exits interface configuration mode.
	Example:
	Router(config-if)# exit

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
31-6	OL-23826-09