Cisco Systems A9014CFD manual Configuring the Twamp Server, Port port-number, 23-7

Chapter 23 Cisco IOS IP SLA

Two-Way Active Measurement Protocol

Configuring the TWAMP Server

Complete the following steps to configure the TWAMP server:

SUMMARY STEPS

1.enable

2.configure terminal

3.ip sla server twamp

4.port port-number

5.timer inactivity seconds

6.end

7.copy running-config startup-config

	Command	Purpose
Step 1
	enable	Enables privileged EXEC mode.
		• Enter your password if prompted.
	Example:
	Router> enable
Step 2
	configure terminal	Enters global configuration mode.
	Example:
	Router# configure terminal
Step 3
	ip sla server twamp	Configures the Cisco ASR 901 router as a TWAMP server, and enters
		TWAMP configuration mode.
	Example:
	Router(config)# ip sla server twamp
Step 4
	port port-number	(Optional) Specifies the port number to be used by the TWAMP server to
		listen for connection and control requests. The same port negotiates for the
	Example:	port to which performance probes are sent. The configured port should not
		be an IANA port or any port used by other applications. The default is port
	Router(config-twamp-srvr)# port
		862.
	9000
Step 5
	timer inactivity seconds	(Optional) Sets the maximum time, in seconds. The session can be inactive
		before the session ends. The range is between 1 to 6000 seconds. The
	Example:	default is 900 seconds.
	Router(config-twamp-srvr)# timer
	inactivity 300
Step 6
	end	Return to privileged EXEC mode.
	Example:
	Router(config-twamp-srvr)# end

To disable the IP SLA TWAMP server, enter the no ip sla server twamp global configuration command.

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		23-7