ADTRAN 6000 Series MANAGEMENT/SNMP Port Configuration Snmp GET Community, Ping Utility

Section 5 User Interface Guide TRACER 6000 Series Integrated System Manual

>MANAGEMENT/SNMP PORT CONFIGURATION > SNMP GET COMMUNITY

Defines the community name for Get access (to poll the TRACER 64x0 for status information). This value must match the Get name defined on the network management stations (NMS). Get access is read only access. The default name is public.

>MANAGEMENT/SNMP PORT CONFIGURATION > SNMP PUT COMMUNITY

Defines the community name for Set access (to change TRACER 64x0 configuration parameters through SNMP). This value must match the Get or Set name defined on the NMS. The default name is private.

>MANAGEMENT/SNMP PORT CONFIGURATION > SNMP TRAP COMMUNITY

Defines the community name for trap destinations. This name must match the community name defined on the NMS. The default name is SNMP_trap.

>MANAGEMENT/SNMP PORT CONFIGURATION > SNMP TRAP HOST #0 - #4

Identifies the IP address in dotted decimal notation of the NMS for the TRACER 64x0 to send SNMP traps to. Up to five trap destinations can be entered.

>PING UTILITY

Figure 32 shows the Ping Utility menu page, which contains the parameters for performing a ping test out of the 10/100BaseT/TX MGMT Ethernet interface.

Figure 32. Ping Utility

>PING UTILITY > PING ADDRESS

Specifies the IP address to ping (in dotted decimal notation).

82 Copyright © 2005 ADTRAN, Inc. 612806420L1-1F