ADTRAN 6000 Series AUX RS232 Interface RJ-45, AUX RS232 Pinout Name Source Description

Section 3 Engineering Guidelines		TRACER 6000 Series Integrated System Manual
	Table 2. TRACER 64x0 LEDs (Continued)
For these LEDs...	This color light...	Indicates that...
STATUS	Green	the module is installed and functioning properly.
MOD1 and MOD2
	Red (solid)	a port on the installed module is currently in alarm.
	Off	no module occupies the slot.
PLAN A	Green (solid)	the TRACER is transmitting on Frequency Plan A.
	Off	the TRACER is not transmitting on Frequency Plan A.
PLAN B	Green (solid)	the TRACER is transmitting on Frequency Plan B.
	Off	the TRACER is not transmitting on Frequency Plan B.
RF LO	Red (solid)	the RSSI level is below suggested minimum threshold
		(approximately 10 dBm above the minimum receive sensitivity).
RF DWN	Red (solid)	there is a communication problem between the local and remote
		TRACERs.

AUX RS232 Interface (RJ-45)

The AUX RS232 interface provides a female RJ-45 terminal connection (wired as a DCE interface), used for a 9600 bps point-to-point connection between the local and remote systems (over the RF link). Table 3 shows the pinout.

Table 3. AUX RS232 Pinout

Pin	Name	Source	Description
1	GND	Common	Signal ground
2	RTS	Attached Equipment	Request to send (unused)
3	TXDATA	Attached Equipment	Transmit data (from attached equipment)
4	DSR	TRACER	Data set ready
5	RXDATA	TRACER	Received data (to attached equipment)
6	CTS	TRACER	Clear to send
7	DTR	Attached Equipment	Data terminal ready (unused)
8	CD	TRACER	Carrier detect

32 Copyright © 2005 ADTRAN, Inc. 612806420L1-1F