ADTRAN 6000 Series system manual DLP-6 Updating the Firmware Using Xmodem

DLP-6 Updating the Firmware Using XMODEM

Introduction

The TRACER 64x0 supports firmware updates of the local and remote systems using TFTP or XMODEM. Use the 10/100BaseT/TX MGMT port and TFTP from a network server or XMODEM (if your Telnet client supports file transfers), or use XMODEM and the CRAFT interface. This procedure outlines the steps for a successful firmware upgrade using the CRAFT interface and XMODEM software. The same XMODEM steps apply for file transfers through your Telnet client (refer to your Telnet client documentation for more details on file transfer specifics). (See DLP-5,Updating the Firmware Using TFTP, on page 103 for instructions on using TFTP.)

Tools and Materials Required

•VT100 terminal or PC with VT100 terminal emulation software

•XMODEM software

To prevent electrical shock, do not install equipment in a wet location or during a lightning storm

Electronic equipment can be damaged by static electrical discharge. Before handling it, put on an antistatic discharge wrist strap to prevent damage to electronic components. Place equipment in antistatic packing material when transporting or storing. When working on equipment, always place it on an approved antistatic mat that is electrically grounded.

612806420L1-1F Copyright © 2005 ADTRAN, Inc. 107