ADTRAN 6000 Series system manual Installing Modules, Instructions for Installing Network Modules

Section 4 Network Turnup Procedure TRACER 6000 Series Integrated System Manual

8.INSTALLING MODULES

Figure 5 shows the slot numbering designation as viewed from the rear of the TRACER 64x0. The functionally identical option slots only accept TRACER 6000 Series modules.

MODULE 1 MODULE 2

Figure 5. TRACER 64x0 Network Module Slot Designation

Access modules are intended to be serviced by qualified service personnel only.

TRACER 64x0 modules are not hot swappable. Remove power from the system before installing or removing the module.

Electronic modules can be damaged by static electrical discharge. Before handling modules, put on an antistatic discharge wrist strap to prevent damage to electronic components. Place modules in antistatic packing material when transporting or storing. When working on modules, always place them on an approved antistatic mat that is electrically grounded.

Instructions for Installing Network Modules

Individual access modules insert in the back of the chassis. Two phillips-head screws hold the modules in place for added security. To install network modules, follow the steps outlined in the following table.

For proper airflow through the system to avoid elevated temperature levels, leave filler plates on any unused slots.

50 Copyright © 2005 ADTRAN, Inc. 612806420L1-1F