ADTRAN 6000 Series system manual Introduction, Tools Required, Unpack and Inspect the System

Section 4 Network Turnup Procedure TRACER 6000 Series Integrated System Manual

1.INTRODUCTION

This section discusses TRACER 64x0 system installation.

Changes or modifications not expressly approved by ADTRAN could void the user’s authority to operate the equipment.

2.TOOLS REQUIRED

The tools required for TRACER 64x0 installation are:

•VT100 terminal or PC with terminal emulation software

•RS-232 (DB-9 male for TRACER 64x0) cable for connecting to terminal

To prevent electrical shock, do not install equipment in a wet location or during a lightning storm.

3.UNPACK AND INSPECT THE SYSTEM

This system MUST be installed by qualified service personnel in a Restricted Access Location.

Each TRACER 64x0 is shipped in its own cardboard shipping carton. Open each carton carefully and avoid deep penetration into the carton with sharp objects.

After unpacking the unit, inspect it for possible shipping damage. If the equipment has been damaged in transit, immediately file a claim with the carrier; then contact ADTRAN Customer Service (see Warranty, Customer Service, Product Support Information, and Training information in the front of this manual).

Contents of Shipment

Your shipment of the base unit includes the following items:

•TRACER 64x0 unit

•RJ-45 to DB-9 connector (ADTRAN P/N 3196ADPT001) for connection to the AUX RS232 port

•6-foot silver satin cable for connection to the AUX RS232 port

•Rackmount brackets

•Power and Alarm connectors

•Spare fuse

•ADTRAN received signal power versus RSSI reference sheet

•TRACER 64x0 Documentation CD

44 Copyright © 2005 ADTRAN, Inc. 612806420L1-1F