ADTRAN 6000 Series system manual Menu Descriptions, System Status, Module Status

TRACER 6000 Series Integrated System Manual Section 5 User Interface Guide

3.MENU DESCRIPTIONS

The remainder of this section describes the TRACER 64x0 menus and submenus.

The menu structure of the TRACER 64x0 system is depicted below as follows:

> MENU PAGE

> MENU PAGE > MENU SELECTION

>MENU PAGE > MENU SELECTION > SUB-MENU

>SYSTEM STATUS

Figure 2 shows the TRACER 64x0 System Status menu page. The status of major system components for both sides of the RF link are displayed, but no configuration can be performed from this view.

			A
	B				B
		Elapsed
Module Status
		Time		Module Status

E

D

Local	Remote
TRACER	TRACER
Status
	Status

	F
								F
Alarm Status
						Alarm Status
				C	RF Status
	G						G
Frequency		Real-Time
						Frequency
	Plan	Signal Values
						Plan
			L
	H
								H
Rx Quality
						Rx Quality

I

Rx Power

J K

Tx Power

		I
	Rx Power
Navigation Reminders		J
	Tx Power

Figure 2. TRACER 64x0 System Status

A. Elapsed Time

The top of the TRACER 64x0 System Status menu page displays the elapsed time the TRACER 64x0 system has been operational since the last power reset.

B. Module Status

A visual status of the current installed modules. The modules are listed in the order they are installed (Module 1 on top and Module 2 on the bottom).

4XT1 MODULE

A visual status of current errors/alarms on the T1 interfaces (for both the local and remote systems) is provided on the TRACER 6420 System Status menu page. The four available T1 interfaces on the module (A through D) are only displayed if the interface is mapped in the DATAPATH PROVISIONING; a – is displayed for inactive, unmapped interfaces. The interface displayed in reverse highlight indicates an active error or alarm condition on the specified interface (A through D). Individual T1 status pages (accessible from the Main menu) provide detailed T1 information.

612806420L1-1F Copyright © 2005 ADTRAN, Inc. 57