ADTRAN 6000 Series system manual Mgmt 10/100BaseT/TX Connection RJ-48C

Section 3 Engineering Guidelines	TRACER 6000 Series Integrated System Manual
A	C	F
Network	DC Power	Antenna
Module Slots	Connection	Connector

B	D	E	G
Ethernet
Interface	Fuse	Alarm	Ground
		Contacts	Lug

		Figure 3. TRACER 64x0 Rear Panel
		Table 6. Rear Panel Description1
	Name	Connector	Description
A	Network Module	N/A	Dual network module slots for system flexibility (shown
	Slots		with a single 4xT1 module and a Quad Ethernet Switch
			module installed)

B	MGMT	RJ-45
C	DC Power	Terminal block

10/100BaseT/TX Ethernet interface for SNMP, TFTP, and Telnet access

21 to 60 VDC power source connection (either polarity referenced to ground)

D	Fuse	N/A	2A, 250 V, 2-inch slo-blo fuse
E	Alarm	Terminal block	External alarm monitoring system connection
F	Antenna	N-type (female)	Antenna feedline cable connection
G	Ground Lug	N/A	Earth ground connection

1 Detailed discussions (including pinouts) of rear panel components (where applicable) follow the table.

MGMT 10/100BaseT/TX Connection (RJ-48C)

The physical Ethernet interface is provided by a single RJ-48C jack (labeled MGMT) that delivers 10/100BaseT/TX for LAN connectivity. The MGMT port is used for Telnet, SNMP, and TFTP access and is not a router interface. The MGMT port has a green LINK LED to indicate a valid link and an amber ACT LED that flashes with data activity on the interface. Table 7 shows the pinout.

		Table 7. MGMT 10/100BaseT/TX Interface Pinout
Pin	Name		Description
1	TX1		Transmit positive
2	TX2		Transmit negative
3	RX1		Receive positive
4,5	—		Unused
6	RX2		Receive negative
7, 8	—		Unused

34 Copyright © 2005 ADTRAN, Inc. 612806420L1-1F