ADTRAN 6000 Series system manual Channel a Channel B, RF Link Configuration RF Band Plan

Section 5 User Interface Guide TRACER 6000 Series Integrated System Manual

>RF LINK CONFIGURATION > RF BAND PLAN

When changing RF band plans on installed links, change the remote end first. If the local end is changed first, remote configuration capability is lost. In the event the local end is changed first and the link is dropped, reset the local end to the previous setting to restore the link.

Sets the band plan for the TRACER 64x0. Each frequency plan is divided into three band plans (1, 2, or 3). Both local and remote TRACER 64x0 systems must be configured with the same band plan (1, 2, or 3) but different frequency plans (A or B). For example, the transmitter at one end of the link will transmit in band plan 1 of frequency plan A (the lower portion of the spectrum) and receive in band plan 1 of frequency plan B (the upper portion). Consequently, the receiver at the other end should receive in band plan 1 of frequency plan A (the lower portion) and transmit in band plan 1 of frequency plan B (the upper portion). (Refer to Figure 6 (TRACER 6410) Figure 7 (TRACER 6420) for the divisions.) The TRACER 64x0 comes factory programmed with RF band plan set to Band 1.

		Channel A				Channel B
2400 MHz	2419	2422	2425	2441.75	2459	2462	2465	2483.5 MHz

Bandplan 1

Bandplan 3 Bandplan 1 Bandplan 3

Figure 6. 2.4 GHz Bandwidth Division

Frequency Plan A Frequency Plan B

	Band plan 1	Band plan 2	Band plan 3		Band plan 1	Band plan 2	Band plan 3
5725 MHz	5744	5747	5751	5787	5824	5827	5831	5850 MHz

Figure 7. 5.8 GHz Bandwidth Division

64 Copyright © 2005 ADTRAN, Inc. 612806420L1-1F